Today I 3D-printed an RPG house I’ve always wanted to make. I could’ve used a resin printer from before, but that would have meant printing it much smaller since the Photon Mono 4 10K only has a 6 to 7 inch build plate.
Printing it on the Bambu Lab A1 was much more satisfying.
I forgot to take a photo before painting, and my paint job turned out pretty rough. I know an AMS Lite would give better results, but I figured I’d save money by using Vallejo paints instead.
Printing and painting this was a lot of fun. The print took almost eight hours, but the end result looks like the perfect medieval RPG house you see in games. I was a bit lazy with the painting, but it still turned out well to me.
If you do tabletop stuff, you should print this. It’s scaled for 28mm figures, so it fits DnD minis perfectly.
